Instruction manual

33
Operation (continued)
Card size setting mode
The printer is designed to load two sizes of cards.
Set the card size according to the card to be printed.
>Card Size
Stanard
EXIT
ENTER
RESET
ENTER
Exit user mode
Set the card size:
2 settings [Standard
and Cybernetic]
Press to select the setting and press to save.
(The electronic beep sounds.)
Standard:
54.0mm × 85.6mm (complies with ISO7810)
Cybernetic:
57.5mm × 85.0mm
*After exiting the user mode, press and then press to initialize.
If initialization is not carried out, the card size setting will have no effect on the printer.
Coercivity setting mode
Set coercivity for writing data on the ISO compatible
magnetic stripe card.
>MG ISO Type
Lo-Co
EXIT
ENTER
Exit user mode
Press to select the setting and press to save.
(The electronic beep sounds.)
Lo-Co
238×10
2
[A/m] (300 [Oe])
Hi-Co
218×10
3
[A/m] (2750 [Oe])
Non-contact IC antenna setting mode
To use non-contact IC cards, set the antenna
position at which the cards stop.
>IC Contact Pos.
None
EXIT
ENTER
Exit user mode
Set IC contact
position:
3 settings
Press to select the setting and press to save.
(The electronic beep sounds.)
None
No contact
Built-in
A built-in contact is being used
Ext. Unit
An IC unit contact is being used
IC contact setting mode
When using IC cards, specify the contact position
to stop the cards.
Test print
Test print is provided for printing a test pattern
contained in the printer (there is only one pattern).
Operating the printer independent of the host computer
enables you to find out the source of trouble if there is
a problem in the system.
>IC Antenna Pos.
None
EXIT
ENTER
Exit user mode
Non-contact IC a
ntenna position:
3 settings
Press to select the setting and press to save.
(The electronic beep sounds.)
None
No antenna
Ext. Unit
An IC unit antenna is being used
Added on
A compact IC unit is being used.
>Test Print
OK?
Printing..
ENTER
EXIT
Exit user mode
Press to carry out test printing.
(The electronic beep sounds.)
A single-sided color pattern is printed. When test
printing is completed, the unit will automatically
return to ready staus.
Transport mode
To set the transport mode.
CAUTION
When shipping or moving the
printer, you must set the transport mode. If the printer
is not set the transport mode, it may have a damage.
>Transport mode
OK?
ENTER
EXIT
Please,
Power off
Press to carry out transport mode.
Exit user mode
(The electronic beep sounds.)
Please turn off the power.
Turnning on the power, then the
transport mode is canceled.