Instruction manual

30
Retransfer mode setting
>Retransfer>
>>Media Type
>>Temp.Level
Std(1000/roll):0
0(Standard)
-2
ENTER
ENTER
ENTER
ENTER
RESET
ENTER
MENU
MENU
MENU
EXIT
EXIT
EXIT
ENTER
EXIT
-2
RESET
ENTER
>>Speed (Front)
MENU
MENU
>>MG Print (JIS)
EXIT
>>Speed (Back)
EXIT
v When setting "On",printing time will be longer by about
1,5s
v No mprovement is expected for the cards with ISO
magnetic stripes.
v Double-sided printing results in a warp depending on
the cards. Change the speed to correct it.
Exit user mode
Set retransfer film
Set film type
Three types of frame settings (1000 frames per film,
250 frames per film,750 frames per film)
v In addition to setting the number of frames, change
the setting when using special films (not yet available).
To use these films, the firmware of this machine needs
upgrading. Please consult your dealer.
Press to select the setting and press to save.
(The electronic beep sounds .)
*After exiting the user mode, press and then press
to initialize.
*After exiting the user mode, press and then press
to initialize.
If initialization is not carried out, the film type setting will have no effect on
the printer.
If initialization is not carried out, the temperature will have no effect on the
the printer.
Set the retransfer temperature.
8 gradations can be set
(from –5 to +2, the larger the value the higher the temperature)
v Retransfer may be not performed well depending on
the cards. Increase the temperature level step by
step until the card can be printed clearly.
Press to select the setting value and press
to save.
(The electronic beep sounds .)
Set the retransfer speed:
5 gradations can be set
(from –2 to +2, the larger the value the faster the speed)
v Partial incompletions may occur depending on the
cards during retransfer. The performance is increased
as the value is lowered. Specify the value mainly on
the retransfer roller temperature setting and use the
speed setting for fine adjustments.
Press to select the setting value and press
to save.
(The electronic beep sounds .)
(The electronic beep sounds .)
Set the reverse retransfer speed:
5 gradations can be set
(from –2 to +2, the higher the value the faster the speed.)
Press to select the setting value and press
to save.
Set the way of the peeling off the retransfer film
2 settings[On and Off]
Depending on the card used,peeling off the retransfer film
may not be complete.
For the cards with JIS magnetic stripes,setting "On" is
recommended.
Change settings according to the retranfer film and card used.