Instruction manual

29
Operation (continued)
Ink mode setting
Change settings according to the ink ribbon used.
>Ink>
>>Black Level
>>Black Mode
>>Ink Type
YMCK:0
0(Standard)
Standard
>>SP-Ink 1 Level
-2
ENTER
ENTER
ENTER
ENTER
MENU
MENU
MENU
MENU
EXIT
EXIT
EXIT
EXIT
ENTER
EXIT
>>SP-Ink 2 Level
-2
or
RESET
ENTER
Exit user mode
Set ink ribbon
Set ink type (YMCK:0, YMCK+PO:2, YMCKK:4)
v Yellow (Y), Magenta (M), Cyan (C) and Black (B)
are provided as the standard ink ribbons. For the
setting to YMCK+PO, consult with your dealer.
Press
to select the setting and press
to save.
(The electronic beep sounds .)
(The electronic beep sounds .)
(The electronic beep sounds .)
(The electronic beep sounds .)
*After exiting the user mode, press and then press
to initialize.
If initialization is not carried out, the ink type setting will have no effect on
the printer.
Set the black value K
7 gradations can be set
(from –3 to +3, the larger the value the darker the printing)
v Small characters printed in black ink may be blurred or
partially darkened. If this is the case, change the setting.
Press to select the setting value and press
to save.
Set the K printing mode:2 options
(Standard and Fine)
v Set to “Fine”mode if blurring still occurs after an
increase in “Black Level.” The printing time slightly
becomes longer in this setting.
v Set to “Fine” mode to avoid blurring
when printing thin by 1 dot lines or small characters.
CAUTION
Press to select the setting value and press
to save.
Special ink SP-Ink 1, SP-Ink 2 darkness level.
7 gradations can be set
(from –3 to +3, the higher the value the darker the printing.)
v Set this darkness level when using a special ink
(not yet available).
Press to select the setting value and press
to save.
v The YMCKK ink ribbon shall be
used only when the face of card is printed by YMCK and
the back by K,or the face by K and the back by YMCK.
Otherwise some error may happen.
CAUTION