Instruction manual

20
Set-up (continued)
Loading cards
Load cards when the printer’s LCD shows the message
“Ready” or “No Card”, and not when printer operations
have stopped due to an error. Cards can also be
loaded when the power supply is not switched on. If
there is a drop in the volume of remaining cards (under
20 cards with a thickness of 0.76mm), the electronic
beep sounds before every feeding.
When “Loading” is displayed on the LCD, do not
open the card tray under any circumstances.
The unit is currently feeding cards. If a message
other than the one above is displayed, cards can
be loaded even while the unit is printing. However,
you are recommended to load cards when the unit
is not printing.
To prevent defective printing caused by
suspended printing or vibration as a result of
opening and closing the card tray, load cards
with care.
Ready No Card
OR
Loading
When using magnetic cards
When using cards with magnetic strips, set the cards in
the following manner.
For JIS II cards:
Place the card with its magnetic stripes upward and
facing the card bracket.
For ISO cards:
Place the card with its magnetic stripes downward and
facing the card bracket.
Printing on cards with magnetic
strips is not guaranteed.
When using contact IC cards
When using contact IC cards, set in the following
manner.
CAUTION
Place the IC card with its IC
terminal inward and facing the
card bracket.
Switching the card thickness
Depending on the material, some 0.25mm thick cards
may not be suitable for printing. Consult your dealer
regarding the materials and specifications of the card
before purchasing.
WARNING
v As for switching the card thickness,
consult your dealer or the service
personnel.
Otherwise injuries or maifunction of the
printer may be caused.
Injury
Electric shock