Instruction manual

Set-up (continued)

Setting cards

Please use cards specified by your dealer. This unit

can take both 0.76 mm-thick and 0.25 mm-thick

cards. The factory setting is for 0.76 mm-thickness.

Fingerprints, soiling, etc. on card

surface can result in print errors. Wear lint-free

gloves when handling.

Open the card tray.

Hold the lower part of the card tray and pull the tray

toward you slowly until it no longer moves.

CAUTION

Caution when loading the retransfer film

cassette and/or the ink ribbon cassette

The following caution shall be kept when the retransfer

film cassette and/or the ink ribbon cassette is removed

because of card jam or other trouble.

Please pay enough attention so that the retransfer film

and/or ink ribbon is maintained at the right position.

Particulary, the ink ribbon is extremely thin, therefore it

apt to slip down when the cassette is removed as

shown in the illustration.

When loaded in this condition, it may cause improper

printing such as INK RUNOUT error, improper color

printing etc.

To avoid this, please handle the ink ribbon and/or the

retransfer film very carefully with hands so that the

media position of take-up side become parallel.

Please do not touch the print side of the ink ribbon and/

or the retransfer film with your hands. Otherwise, it may

cause improper printing.

When adjusting the print position of the retransfer film

and/or ink ribbon, please follow the instruction label

attached on the cassettes.

Improper Winding

Adjust the position with hands so

that the media position of take-up

side and supply side becomes parallel