Product Manual A
Table Of Contents
- section 1: INTRODUCTION
- section 2: GENERAL SAFETY INFORMATION
- section 3: Regulators: Safety and Operation
- section 4: When You Finish Using the Regulator
- section 5: Statement of Warranty
- CHAPITRE 1: INTRODUCTION
- CHAPITRE 2: Informations Générales de Sécurité
- CHAPITRE 3: Régulateurs: Sécurité et Fonctionnement
- CHAPITRE 4: Quand Vous Avez Fini D’utiliser le Régulateur
- CHAPITRE 5: GARANTIE
- SECCIÓN 1: INTRODUCCIÓN
- SECCIÓN 2: INFORMACIÓN GENERAL DE SEGURIDAD
- SECCIÓN 3: Reguladores: Seguridad y Manejo
- SECCIÓN 4: Una Vez Que Termine de Utilizar el Regulador
- SECCIÓN 5: DECLARACIÓN DE GarantÍA
4-16
SECTION 4:
WHEN YOU FINISH USING THE REGULATOR
1. Close the cylinder valve.
2. Open the valve on the downstream equipment. This drains all
pressure from the system.
3. Close the valve on the downstream equipment.
4. Turn the adjusting screw counterclockwise to release the ten-
sion on the adjusting spring.
5. Check the gauges after a few minutes for verification that the
cylinder valve is closed completely.
4.01 STORAGE
When the regulator is not in use and has been removed from the
cylinder, it should be stored in an area where it will be pro tected
from dust, oil, and grease. The inlet and outlet should be capped
to protect against internal contamination and prevent insects
from nesting.