Install Instructions

Viconics Technologies Inc. | 9245 Langelier Blvd. | St.-Leonard | Quebec | Canada | H1P 3K9 | Tel: [phone] | Fa x : (514 ) 321-4150
028-0450-00
www.viconics.com | [e-mail] November 2014
© 2014 Viconics TEchnologies. All rights reserved.
VT8000 Series
4
ZigBee Pairing Procedure
Bind Room Controller to MPM
This procedure shows you how to bind a Room Controller to a MPM using Building Expert.
CONFIGURE VT8000 SERIES
1. In the center of the top of the screen, touch and hold this point for 3 seconds to enter setup mode.
2. Select Network.
3. Select COM address.
• Using the up/down arrow icons, enter the COM address value.
• This should be unique to the device for networked installations.
4. Select ZigBee pan. ID.
• Using the up/down arrows, enter the ZigBee pan. ID value.
• This value should be 499 or less if the Room Controller is to be part of a network of Room Controllers, and 500 or greater if the
Room Controller will be stand-alone.
5. Select ZigBee channel.
6. Using the up/down arrows, enter the channel number.
7. Select the Back to Setup icon
1/2 Setup
Network
Configuration
Setpoints - Display
Service view
Test outputs
Language selection
Previous
page
Next
page
Back to
Setup
Change
value
Com address
ZigBee Pan ID
1/2 ZigBee Network
ZigBee channel
0x0000
ZigBee short
0x0000
IEEE address
No NWK
ZigBee status
254
0
10