Install Instructions

Viconics Technologies Inc. | 9245 Langelier Blvd. | St.-Leonard | Quebec | Canada | H1P 3K9 | Tel: [phone] | Fax: [phone]
028-0450-00
www.viconics.com | [e-mail] November 2014
© 2014 Viconics TEchnologies. All rights reserved.
VT8000 Series
2
ZigBee Pairing Procedure
Quick setup
The quick set-up assumes all back-end configurations of the stand alone Room Controller acting as coordinator or the Multi-Purpose
Manager (MPM) coordinator for the ZigBee network have already been done. It also assumes the user is familiar with the Permit Join
function and the Wireless Ecosystem screen functions.
PROCEDURE
1. Set Permit Join on your Room Controller (or networked MPM coordinator if used) to On.
2. Go to first unused Zone screen in Wireless Ecosystem section of Room Controller’s interface.
3. Insert battery or remove pull tab (for contact sensors) to activate ZigBee sensor.
4. Verify sensor has joined network, and that on Zone screen the Paired field status reads Yes.
5. Set the Set function to parameter to the correct setting.
6. Set Permit Join on your Room Controller (or networked MPM coordinator if used) to Off.
7. Conditional to use of door or window contact sensors:
a) Go to first screen in Configuration section of interface.
b) For window sensor, set UI16 to Window.
c) For door sensor, set UI17 to Door Dry.
8. Physically install the sensor.
TROUBLESHOOTING
If the short procedure described here is insufficient or an MPM or Room Controller needs to be configured, refer to the full procedure
described later in this document.