Installation Guide User Manual

Motion Sensor
Installation Guide
4
© 2014 Viconics. All rights reserved.
Viconics Technologies Inc. | 9245 Langelier Blvd. | St.-Leonard | Quebec | Canada | H1P 3K9 | Tel: [phone] | Fax: [phone]
028-6078-00 www.viconics.com | [e-mail] October 2014
INSTALL MOTION SENSOR
This procedure shows you how to install the Motion Sensor to the desired
location. The Motion Sensor can be installed vertically, horizontally, or upside
down on a flat surface or in a corner.
1. Affix 2-sided tape to desired location (Figure 1).
2. NOTE: ensure tape is flush with surface and securely affixed to surface.
3. Set Motion Sensor on 2-sided tape and press firmly to secure Motion Sensor
in place.
4. Test Motion Sensor. Refer to "Device Function" on page 4.
DEVICE FUNCTION
Figure 1
• Always test Device before leaving job site.
• Avoid installing Device directly on metal surfaces. Installation on metal can reduce transmission range.
• Ensure Device is installed in dry location away from water, moisture, and rain.
Function and LED Indicators
BUTTON LED ACTION LED DESCRIPTION
2 times GG Network Status
GGG
Joined
RRR Not Joined
YYY Re-Join in Process
4 Times GGGG Network Join
YRY
Searching for Network
YGY Device Being Configured
GGG Device Joined
RRR Device Failed to Join
8 Times
GGGGGGGG
Forced Re-Join YYY Re-Join, Searching for Parent
10 Times
GGGGGGGGGG
Network leave and join a
new Network
RRR Leave if Joined
GGGGG Defaults Restored
G = Green
Y = Yellow
R = Red
No Action
Y Wrong Button Press
YGR Device Busy
Power Up RRYYGG
2-sided tape