Installation Guide Owner's manual

Ceiling Mounted Sensor
Installation Guide
4
© 2014 Viconics. All rights reserved.
Viconics Technologies Inc. | 9245 Langelier Blvd. | St.-Leonard | Quebec | Canada | H1P 3K9 | Tel: [phone] | Fax: [phone]
028-6077-00 www.viconics.com | [e-mail] October 2014
INSTALL CEILING MOTION SENSOR
1. Observe Sensor placement conditions before you install Sensor. Refer to
"Sensor Placement" on page 2.
2. Secure Mounting Plate to overhead surface with two screws (Figure 1).
NOTE: ensure screws are tight and Mounting Plate does not move easily. Do
not torque screws.
3. Set Sensor Housing assembly on Mounting Plate (Figure 2).
4. Rotate Sensor Housing assembly clockwise until it locks in place.
NOTE: ensure Sensor Housing assembly fits snugly to Mounting Plate.
5. Test Ceiling Motion Sensor. Refer to "Verify Sensing Motion" on page 3.
DEVICE FUNCTION
Figure 2
• Always test Device before leaving job site.
• Avoid installing Device directly on metal surfaces. Installation on metal can reduce transmission range.
• Ensure Device is installed in dry location away from water, moisture, and rain.
Figure 1
Function and LED Indicators
BUTTON LED ACTION LED DESCRIPTION
2 times GG Network Status
GGG
Joined
RRR Not Joined
YYY Re-Join in Process
4 Times GGGG Network Join
YRY
Searching for Network
YGY Device Being Configured
GGG Device Joined
RRR Device Failed to Join
8 Times
GGGGGGGG
Forced Re-Join YYY Re-Join, Searching for Parent
10 Times
GGGGGGGGGG
Network leave and join a
new Network
RRR Leave if Joined
GGGGG Defaults Restored
G = Green
Y = Yellow
R = Red
No Action
Y Wrong Button Press
YGR Device Busy
Power Up RRYYGG
Mounting Plate
Sensor Housing
LED
Button