User's Manual

English

Wiser Air Installation Guide 1-855-559-4737 www.wiserair.com

Before You Start

Read the information in this section in its entirety before you begin the installation of Wiser Air.

TOOLS PROVIDED MATERIALS

• Wire stripper

• Drill with 3/16in (4.8mm) drill bit

• Screwdriver

• Level

• Voltmeter

• Wiser Air front

• Wiser Air back plate

• Wiser Air trim plate

• Screws (x2) and anchors (x2)

• Wire extender

• Installation guide

• Wire labels

Preparation

• Make sure that your existing thermostat is in off mode.

• Switch your air conditioning and/or heating system breaker to the off position.

• We recommend that you use a properly isolated voltmeter to conrm power is off.

• Wiring must conform to all building codes, regulations, and ordinances as required

by local and national code and regulation authorities.

• Ensure all electrical loads (air conditioners, heating elements, etc.) that will be

controlled by Wiser Air are connected to appropriate fuses to prevent overload.

• Ensure Wiser Air is suitable for the environment. Check the voltage compatibility

(~24V).

• Wiser Air outputs are rated at 1A maximum.

• Security is a top priority for Wiser Air. Wi-Fi must be at least WPA2 password

protected.

Location

• If this is a new installation, install Wiser Air 5ft (1.52m) above the oor surface in

accordance with applicable building codes.

• Install Wiser Air in areas with frequent occupancy and airow.

• Avoid installing Wiser Air in locations near heating/cooling devices.

• Avoid installing Wiser Air in areas with direct sunlight. The screen may become

unreadable due to direct sunlight or reection from windows, and temperature

regulation may be affected.

• Avoid installing Wiser Air behind doors, near corners, near air vents, or in areas

with high dust concentration.

Mounting

1. Keep the front of Wiser Air separate from the back plate before mounting.

2. Align the Wiser Air back plate against a wall using a level and mark the placement

of the mounting holes.

3. Using a 3/16in (4.8mm) drill bit, drill a hole to a depth of 1in (25.4mm) and install

wall anchors at the marked locations. If a stud is present, no anchors are

necessary.