User's Manual

English

Wiser Air Installation Guide 1-855-559-4737 www.wiserair.com

TIP: Before proceeding further determine if you require the optional trim plate.

TIP: Before proceeding further check if you require a wire extender (see Appendix).

4. Disconnect the wiring of the existing thermostat and remove the back plate.

TIP: Acceptable wire gauge for use with Wiser Air is solid 18 to 22 AWG (0.33 to 0.82mm²).

5. Pull the wires 6in (15cm) out of the wall if they are not already pulled out.

6. Insert the wires through the central hole in the Wiser Air back plate.

7. If required, strip each wire 0.25in (0.6cm) from the end (does not apply to

replacing pre-existing units).

8. Gently push the wiring back into the hole.

TIP: See the Wiring terminals section (p.11) in this guide before proceeding further.

Figure 2 : Wiring connection and back plate attachment (optional trim plate shown).