User's Manual
SED - WIN and SED - DOR
8
Wireless Door/Window Switch
All brand names, trademarks and registered trademarks are the property of their respective owners. Information contained within this document is subject to change without notice.
Schneider Electric One High Street, North Andover, MA 01845 USA Telephone: +1 978 975 9600 Fax: +1 978 975 9674 http://www.schneider-electric.com/buildings
II-SE8000-SEDWINDOR-US.EN.10.2013.v1 October 2013
© 2013 Schneider Electric. All rights reserved.
Pairing Associating Switches with Controllers
1. Remove pull tab from battery holder to power-up switch.
2. Verify or set configuration parameter BI1 or BI2 to None to erase current
associated devices.
3. Set configuration parameter BI1 to Window and BI2 to DoorDry.
4. To reset wireless switch to its factory default settings if previously
associated, short switch and hold for 20+ seconds. 5 short blinks will
confirm reset (see Figure-5).
5. Short switch once for less than 3 seconds and bring switch to left of con-
troller where COM module is located.
6. Hold switch as close as possible to controller during pairing process (see
Figure-6).
7. LED displays one long blink followed by one short blink to indicate switch
is in pairing mode.
8. LED displays 2 short blinks in succession. Make sure to place switch
closely to COM module of controller.
9. LED displays five short blinks to indicate switch is paired.
10. Quickly short switch and LED displays a blinking pattern matching the cor-
responding MAC address:
Example:MAC=43ifLEDshows4shortblinksfollowedbyapauseand
another 3 short blinks.
Multiple Switch Configuration
In a multiple switch configuration, up to 20 switches can be linked to one
controller. Repeat steps 5 to 9 in pairing process procedure to add multiple
wireless switches.
When a multiple switch configuration is modified, such as removing a switch, a
reset is required according to the following:
1. To reset wireless switch to its factory default settings, short switch and
hold for 20+ seconds. Five short blinks confirm reset.
2. Set configuration parameter BI1 or BI2 to None and then back to BI1 or
BI2 to erase removed wireless switch.
Figure-6 Switch/Controller Proximity During Pairing
Figure-5 Shorting the Switch