User guide

63
- RTP TTL: Enter a value between 1 and 255. If a network status is smooth, enter a lower
value. However, if a network status is poor, enter a higher value. When there are many
network cameras or users, a higher value may cause a heavy load to the network.
Consult with a network manager for detailed information.
- Always enable multicast: Check the box to start multicast streaming without opening an
RTSP session.
When the settings are complete, click Save, or click Reset to revert to previously saved settings.
 UPnP
The network camera includes support for UPnP™. UPnP is enabled by default, so the network camera
is automatically detected by operating systems and clients that support this protocol. Enter a name in
the Friendly name field.
Note: UPnP™ must be installed on your workstation if running Windows XP. To do this, open the
Control Panel from the Start Menu and select Add/Remove Programs. Select Add/Remove Windows
Components and open the Networking Services section. Click Details and then select UPnP as the
service to add.
When the settings are complete, click Save, or click Reset to revert to previously saved settings.