User guide

30
 Image
• Image Appearance
This page provides access to the advanced image settings for the network camera.
- Brightness: The image brightness can be adjusted in the range 1-10, where a higher value
produces a brighter image.
- Contrast: Adjust the image's contrast by raising or lowering the value, 1-10, in this field.
- Saturation: Select an appropriate level by entering a value in the range 1-10. Lower values
mean less color saturation.
Hue: Select an appropriate level by entering a value in the range 1-10. The value
distinguishes color, such as red, yellow, green, or violet.
- Sharpness: Controls the amount of sharpening applied to the image. A sharper image
might increase image noise especially in low light conditions. A lower setting reduces image
noise, but the image would be less sharp. Select 1-5.
- Enable flip image: Check this checkbox to flip the image.
- Enable mirror image: Check this checkbox to mirror the image.
- Enable Noise Reduction: Check this checkbox to reduce an image noise.
- Enable Wide Dynamic Range: Check this box to use the WDR function.
- Enable Defog: Check this box to use the Defog function and select the level of strength.
When the settings are complete, click Save, or click Reset to revert to previously saved settings.