Product specifications
Quick Installation Guide
4.5 Network Camera Setup
This section describes how to configure the V-CELL-IP Camera. It is intended for Administrators, who
have unrestricted access to all the Setup tools, and Operators, who have access to the settings for
Basic, Live View, Video & Image, Event, and System Configuration.
You can configure the V-CELL-IP Camera by clicking Setup in the top right-hand corner of the Live
View page. Click on this page to access the online help that explains the Setup tools.
When accessing the V-CELL-IP Camera for the first time,
the “Admin Password” dialog appears. Enter your admin
name and password, set by the administrator.
Note: If the password is lost, the V-CELL-IP Camera
must be reset to the factory default settings.
See “4.6 Resetting to the Factory Default Settings”.
4.6 Resetting to the factory default settings
To reset the V-CELL-IP Camera to the original factory settings, go to the Setup>System >Maintenance
web page (described in “3.5.4 System>Maintenance” of the User’s Manual) or use the control button
on the V-CELL-IP Camera, as described below:
Follow the instructions below to reset the Network Camera to the factory default settings using the
Reset Button.
1. Switch off the V-CELL-IP Camera by disconnecting the power adapter.
2. Open the lens cover.
3. Press and hold the Control Button (SW1) on the board with your finger while reconnecting
the power.
4. Keep the Control button (SW1) pressed for about 2 seconds.
5. Release the Control Button (SW1).
6. The V-CELL-IP Camera resets to factory defaults and restarts after completing the factory reset.
The unit now obtains the IP address automatically via DHCP.
7. Close the lens cover.
CAUTION: When performing a Factory Reset, any previously saved settings will be lost.
4.7 More Information
For more information, see the V-CELL-IP Camera User’s Manual, which is available on the CD included
in this package.
12