User guide

3.8 Resetting to the factory default settings
To reset the Network Camera to the original factory settings, go to the Setup>System> Maintenance
web page (described in “3.5.5 System > Maintenance”) or use the control button on the network
camera, as described below:
• Using the Reset Button
Follow the instructions below to reset the Network Camera to the factory default settings using
the Reset Button.
1. Switch off the Network Camera by disconnecting the power adapter.
2. Open the rear cover.
3. Press and hold the Control Button (SW1) on the board with your finger while reconnecting
the power.
4. Keep the Control button (SW1) pressed for about 2 seconds.
5. Release the Control Button (SW1).
6. The network
camera resets to factory defaults and restarts after completing the factory
reset. The unit now obtains the IP address automatically via DHCP.
7. Close the rear cover.
CAUTION: When performing a Factory Reset, you will lose any settings that have been saved.
70