User guide

To create a motion or mask window, follow steps:
1. Click the right button of mouse to see the mouse menu.
2. Select New Motion (or Mask) Window in the mouse menu.
3. Click and drag mouse to designate a motion area.
• Motion Detection Setting
The behavior for each window is defined by adjusting the Threshold and Sensitivity, as described
below.
A motion index is a set of parameters describing Window Name, Type, Threshold, Sensitivity, and
Dwell Time. Window Type is Include at the Motion, and Exclude at the Mask window.
- Threshold: Sets up the threshold for the motion detection. Threshold judges the amount of
change in the area. Select from 1-100; a lower number increase frequency of alarms.
- Sensitivity: Sets up the sensitivity for the motion detection. Sensitivity measures the
level of motion in each motion area. Select from 1-100, 1 being the least sensitive to
alarm condition.
- Dwell Time: Set the hold time an event lasts from the point of detection of a motion
(hold time).
You can also modify or delete a motion index. It can be deleted using the table and modified by
selecting it and changing parameters in the table. When the settings are complete, click Save, or
click Reset to revert to previously saved settings.
 Network Loss
This is used to trigger the event every time the network connection fails. Select “Enable” to activate
the Network Loss event. Select a dwell time for how long the event will last from the point of
detection.
When the settings are complete, click Save, or click Reset to revert to previously saved settings.
42