Product specifications

V-CELL-HD Quick Installation Guide

2.2 Connections

• Connecting to the RJ-45

Connect a standard RJ-45 cable to the network port of the network camera. Generally a

cross-over cable is used for directly connection to PC, while a direct cable is used for connection

to a hub.

 Micro SD memory slot on the board

Insert the SD memory card (customer-supplied).

• Connecting Alarms

 Alarm-In: External devices can be used to signal the network camera to react upon events.

Mechanical or electrical switches can be wired to the Alarm In and GND connectors.

 GND (Ground): Connect the ground side of the alarm input and/or alarm output to the GND

connector.

 Alarm Out: The network camera can activate external devices such as buzzers or lights.

Connect the device to the Alarm Out and GND connectors.

• Connecting the Power

Connect the power of 12 VDC or 24 VAC for the network camera. Connect the positive (+) pole

to the ‘+’ position and the negative (-) pole to the ‘-’ position for the DC power. Use

Certified/Listed Class 2 power source.

• Connecting Service Monitor Port

The Service Monitor output port is located on the board of the camera and is used for easy OSD

setup.

▶ ID & IP assignment

To make changes in the OSD menu, the optional OSD controller can be used to set Camera Title

and IP Address.

1. Connect the OSD Controller to the Service Monitor port of the network camera.

2. Connect Service Monitor and the Video Output port of the OSD Controller.

3. Press the SET button on the controller to access the Main Menu.

4. Change camera ID and IP address as needed. Additionally, the Name (or title) of the camera

can be changed. Use the ↑↓←→ buttons on the controller to change the parameters.

5. Select SAVE or CANCEL to exit the Main Menu.