Installation guide

12
Size
Video output resolution. See the output resolution table that follows.
Frame rate
1 ~ 30fps (60Hz) / 1 ~25fps (50Hz)
GOP Size
1 ~ 60 frames
Bit-rate control (CBR or VBR)
When using H.264 compression, if there is only limited bandwidth available, a constant bit
rate (CBR) is recommended, although this may compromise image quality. Use a variable
bit rate (VBR) for the best possibly image quality.
Average Bit-rate (512Kbps ~ 10Mbps)
Recommended bit rate for D1 or VGA : 800Kbps ~ 1Mbps
Recommended bit rate for 1.3M (720p) : 3Mbps ~ 4Mbps
Recommended bit rate for 2.0M (1080p) : 6Mbps ~ 8Mbps
Boost Quality
The Boost feature is used in conjunction with Video Motion Detection (VMD). When this
feature is turned ON, the Boost FPS can be set to a different value than the Frame Rate set
for the V992D-IR in the field above. When motion is detected, the V992D-IR will boost the
fps from the regular level set for the V992D-IR to this boosted level for the duration of the
motion. Boost Quality can be set ON or OFF. (Note that multicasting may not be available
with the firmware you received; check the Vicon website for updated firmware.)
Quality
1 ~ 100 This parameter is only available in M-JPEG mode.
Anti-Flicker mode (Flicker less mode)
60Hz / 50Hz
Video Mirroring
Select Video Mirroring mode NONE/HORIZONTAL/VERTICAL/FLIP(H+V)