Installation guide

2
3. Status LED
LED Color Indication System Status
Network Blue
On Power On.
Flash Network is active
Status
Red Flash
Firmware Upload in progress
HW Factory Default in progress
Green
Flash Booting up
On Normal
4. Reset Button
Press this button to reset the camera.
5. Video output for service monitor
The analog video output is available when installation mode is set to ON. Use accessory
cable to video output.
6. Lock nut
To set lens position, loosen the nut and adjust the position.
7. Focus adjustment
Use focus adjust ring for lens adjustment.
8. Network (RJ-45 PoE required)
The V992D-N4 connects to the network via a standard network cable, and automatically
detects the speed of the local network segment (10BaseT/100BaseTX Ethernet). This
socket must be used to power the V992D-N4 via Power over Ethernet (PoE). The
camera auto-senses the correct power level when using a PoE (Class 2) switch, router
or injector.