Installation guide

12
Size
Video output resolution. See the output resolution table that follows.
Frame rate
1 ~ 30fps (60Hz) / 1 ~25fps (50Hz)
GOP Size
1 ~ 60 frames
Bit-rate control (CBR or VBR)
When using H.264 compression, if there is only limited bandwidth available, a constant bit
rate (CBR) is recommended, although this may compromise image quality. Use a variable
bit rate (VBR) for the best possibly image quality.
Average Bit-rate (512Kbps ~ 10Mbps)
Recommended bit rate for D1 or VGA : 800Kbps ~ 1Mbps
Recommended bit rate for 1.3M (720p) : 3Mbps ~ 4Mbps
Recommended bit rate for 2.0M (1080p) : 6Mbps ~ 8Mbps
Boost Quality
The Boost feature is used in conjunction with Video Motion Detection (VMD). When this
feature is turned ON, the Boost FPS can be set to a different value than the Frame Rate set
for the camera in the field above. When motion is detected, the camera will boost the fps
from the regular level set for the camera to this boosted level for the duration of the motion.
Boost Quality can be set ON or OFF. (Note that multicasting may not be available with the
firmware you received; check the Vicon website for updated firmware.)
Quality
1 ~ 100 This parameter is only available in M-JPEG mode.
Anti-Flicker mode (Flicker less mode)
60Hz / 50Hz
Video Mirroring
Select Video Mirroring mode NONE/HORIZONTAL/VERTICAL/FLIP(H+V)