Installation guide

10
4. Setup
The V992D-N4 is configured from the Setup link, which is available on the top left hand side
in the web interface. This configuration could be done by:
Administrators, who have unrestricted access to all settings under the Setup tab.
Accessing the Setup link from a browser
1. Start your web browser and enter the IP address or host name of the camera into the
address bar.
2. The Live View page is now displayed. Click on the Setup tap.
4.1 Install
4.1.1 Installation Setup
Installation Mode allows use of the analog BNC output from the camera to connect the
camera
NTSC, PAL: Analog Output is enabled.
OFF: Analog output will be disabled.