Installation guide

5. Power Connector
12 VDC or 24 VAC power connector
6.
Micro SD Card
Save snapshot images and video onto a Micro SD card.
7. Reset Button
Press this button to restore the camera configuration to its factory default settings.
8. Reset LED
9. Status LED
LED Color Indication System Status
Status Green
On Network connection is established.
Flash Camera is booting up.
Reset Red Flash
Firmware Upload in progress.
Hardware Factory Default in progress.
10. Video Output for Service monitor
This analog video output is available when installation mode is set to ON. Use supplied accessory
cable to video output.