Installation guide

3.2 Accessing the Camera from the Internet
Once installed, the camera will be accessible on the Local Area Network (LAN). Then you must
configure the router/firewall to allow incoming data traffic to access the camera from the Internet. For
security reasons this is usually done on a specific port, using port forwarding. Please refer to the
documentation for router/firewall for further instructions on port forwarding.
3.3 Adjusting the Image and Focus
To adjust the position of the lens:
Fixed Lens
1. Open the Live view page in your web browser.
- Select the Setup tab and open the Installation page.
- Set ‘Installation Mode’ to ‘ON’ and select the ‘Video Format' (NTSC).
2. Connect
supplied video monitor cable to video output connector, then connect it to analog
monitor with coaxial cable.
- Unscrew the zoom puller on the lens by turning it counter-clockwise.
- Adjust the zoom setting and re-tighten the zoom puller.
- Unscrew the focus puller on the lens to adjust the focus and re-tighten the focus puller.
3. Check the image from the Live view page on your web browser.
- Set ‘Installation Mode’ to ‘OFF’ to resume normal camera operation.
NOTE: DC Auto-Iris should always be disabled while focusing the camera. This will set the iris to the
wide open position, which yields the smallest depth of field, and thus the best conditions for focusing
the lens. When the focus has been set by using this method, it will maintain its focus in any kind of
lighting conditions.
Motorized Lens
1. Open the Live view page in your web browser.
- Select the Setup tab and open the Video -> Camera page.
- Click ‘Lens Adjustment’.
2. Set the desired Zoom and Focus (and Iris if applicable) positions.
3. Click ‘One Push Focus’ button to adjust focus automatically or set focus manually.
NOTE: DC Auto-Iris should always be disabled while focusing the camera. This will set the iris to
the wide open position, which yields the smallest depth of field, and thus the best conditions for
focusing the lens. When the focus has been set by using this method, it will maintain its focus in
any kind of lighting conditions.
Note that the screen displayed may
be slightly different than shown here
due to the type of lens supplied with
the camera.