Technical data

8Factorysettings
CamTel
svr
37
8 Factory settings
ThischapterprovidesanoverviewoftheCamTel
svr
factorysettings.
ItisstronglyadvisedtocheckCamTel
svr
allsettingsandtoconfigurethese
according to application specific requirements. You can always revert to
factorysettingswithadevicereset(see“Devicereset”onpage24).
General settings Part 1/2
Device name Nodevicenameentered
User Nouserentered
Passwords Nopasswordsentered
Summer/winter time Adjustautomatically;timezone=Europe
Connections
Network (TCP/IP) IPaddress=192.168.31.95;subnetmask=255.255.255.0;gateway=
192.168.31.1;port=3000;DNSserver1:1.2.3.4;DNSserver2:1.2.3.4;
maximumconnectionspeed=>400KB/s=3.13MBit/s(correspondingto
about500KB/sor3.9MBit/sdependingondevice,networkload,andPC
configuration)
External MODEM Baudrate=115,000Baud;tone/pulsedialnotactivated;numberofrings=1;
initialisationcommand=ATE0V1S0=0;dialcommand=ATD;lastcaller=not
defined
Integrated ISDN TA MSN=notdefined;adapterresetevery=60minutes
telephonenumber/IPaddress=notdefined;callback=notactivated;
numberrepeats=4;intervalbetweencalls(s)=4;intervalbetweentwo
repeats(s)=30s;Alwayscallalltelephonenumbers=notactive
Camera-specific settings
Live image quality Percamera=512x256+;pergroup=512x256+;persetof4’=512x256+;
Persetof10’=256x80;conditionalrefreshmode=active
Camera settings Forallcameras:Camera=active;cameraname="Camera1","Camera2",
etc.;brightness=100%;contrast=100%;colour=on
Camera groups Forallcameragroups:nogroupnameentered,nogroupassigned
Motion fields Not active; detection areas= all active (only visible on activation of motion
fieldsforthecorrespondingcamera)
Alarm
Alarm inputs Alarmenableinput:Status=enabled;connect=notactive;activeif=control
inputopen(highactive)
Alarminput:connect=active;activeif=controlinputclosed(lowactive)
Camera alarm Forallcameras:Trigger=normallyopencontact;connect=notactive
Motion Forallcameras:motionalarm=notactive;
sensitivity=motion-
pre-alarm archive
pre-alarm settings Forallcameras:Recordingnotactive;inteval[s]=1