Technical data

ManualsBrandsVicon ManualsHome building and DecorSVR-CC

4Commissioning

CamTel

svr

4 Commissioning

This chapter describes the basic procedure for successfully commissioning

yourCamTel

svr

andprovidestipsforconfigurationanddesignstrategies.The

online manual for CamControl LITE and CamControl PRO software

provides further information on configuration software and the menus

relevant to configuring your application. For clearness, the following

information refers to  CamControl LITE software. CamControl PRO

software providesidenticalfeatures and can be used for commissioning as

wellwithoutany

limitation.

4.1 First steps

1. InstallCamTel

svr

asdescribedinchapter"Systemdescription", section

"Mountingandsettingup"andswitchthedeviceon.(see“Mounting

andsettingup”onpage12)

2. Connect all input and output lines to your CamTel

svr

 unit now, if

possible.Allrequiredplugsareincludedinthescopeofdelivery.Refer

tochapter"Pinassignmentandfunctionality".Fortheinstallationofa

camera system with PTZ control, additional information is required.

Pleaserefertotheinstallationinstructionsofthecameramanufacturer

andtherespectivesupplementarydocumentsbyHeiTel. Also

observe

the information provided in chapter"PTZ control"(see“PTZ control”

onpage31)

3. InstalltheCamControl LITEsoftwareforoperation,alarmverification,

and configuration from the installation CD. Please observe the

installationinformation intheonline manualof the same name. This

manualisincludedintheinstallationCD.

4. Connect the CamTel

svr

 to the PC with the CamControl LITE

software.Useeitherthenullmodemorthenetworkcable.Bothcables

areincludedinthedeliveryofyourCamTel

svr

5. Start the CamControl LITE software and use option "Connect" to

connecttoyourCamTel

svr

unit,observingthefollowing:

■ If you use a null modem cable: Open CamControl LITE

software in offline mode. Go to menu item Settings,menu

itemPort A,menuitemMode.ActivateoptionNull modem.

■ Ifyou useanetworkcable:OpenCamControl LITEsoftware

inofflinemode.GotomenuitemSettings,menuitemPort

A, menu item Mode. Activate option TCP/IP. In addition,

include your CamTel

svr

 unit as new transmitter in the

transmitter list, including the CamTel

svr

 TCP/IP address. The

factorysettingsare:IPaddress=192.168.31.95;subnetmask

=255.255.255.0;ActivatethetransmitterlistwithoptionDial.

6. RefertotheCamControl LITEsoftwareonlinemanualforallfurther

stepsconcerningcommissioningandconfiguration.