Technical data

ManualsBrandsVicon ManualsHome building and DecorSVR-CC

3Systemdescription

CamTel

svr

3.7 Pin assignment and functionality

General

All terminals are pluggable. It is recommended to remove the screw type

terminal for wiring, especially of the terminal block. This makes wiring of

incomingandoutgoinglinesmoreconvenient.Thescrewtypeterminalsare

groupedbyfunctionality.

28-/ 34 pin terminal block

Pin Labeling/description Type Function

1 RS-485- Serial

(D-)

Usethisterminaltoconnectupto10remotecontrolcameras

or other compatible devices (e.g. matrix) with RS-485/RS-422

interfaces. Refer to Chapter "PTZ Control"(see “PTZ control”

on page 31) for a list of devices/camera systems and

informationontherespectivedevicedrivers/protocols.

2 RS-485+ Serial

(D+)

3 Ground commongroundforallinputsof

type"controlinput"

4RS-232Tx Serial

TxD

Usethis terminal toconnect 1 remote control camera or one

othercompatibledevice(e.g.crossbar)withRS-232interface.

RefertoChapter"PTZControl"(see“PTZcontrol”onpage31)

for a list of devices/camera systems and information on the

respectivedevicedrivers/protocols.

5RS-232Rx Serial

RxD

6 Ground common

groundforallinputsoftype"controlinput"

7Al.a/d Control

input

Arm/Disarminputforenabling/disablingdialuptoa

CamControlreceiverPC,controlledby"Controlin","Alin",

and"MotionDetection".

8 V.out Control

input

Pushbuttonformanualcontrolofvideooutput(V.out).Switch

camerasindividually,orstartandstoppredefinedcamera

sequences,depending

onconfiguration.Thisfeatureisonly

availableifacamerasequencehasbeenprogrammed.

1. For stopping camera sequences, control inputs mustbe

switched to ground. The camera currently switched on

willremainactiveaslongasthepushbuttonispressed.

2. As soon as the control input is switched to high

resistance,the

camerasequenceisstartedwithadelayed

switchtothenextcamerainthesequencerlist.

3. Switch sequencer cameras manually by: Stopping the

sequence as described under 1. To switch on the next

camera,brieflyswitchthecontrolinputtohighresistance

andthenagaintoground.Toactivatesequencermode,

keepthe

controlinputswitchedtohighresistance.

9Al.in Control

input

Alarminputfordialupwithautomaticswitchingofvideoinput

1(V1in)toaCamControlreceiverunit.

Note: The operation of this input always depends on the status

of arm/disarm input "Al. a/d"

⊥