Technical data

3Systemdescription
16 CamTel
svr
3 Pushbutton Reset,
notlabelled
Deleteuserspecificpasswordsandusernamesbypressing
pushbuttonReset(e.g.withthetipofaball pointpen)for10
seconds,untilLEDPowerstartsflashing.Subsequently CamTel
svr

willberestartedautomatically.Nootherpasswordsorsetupdata
willbedeletedbesidesuserpasswords.
4V1-V4for
CamTel
svr
4,
V1-V10for
CamTel
svr
10,
LEDs-yellow
AnilluminatedLEDincombinationwithilluminatedLEDError(6)
indicatesvideosignalfailureoftherespectivevideoinput. Tip:
Deactivate unused camera inputs using device settings.
5 PushbuttonV.out-
black
Pushbuttonformanualcontrolofvideooutput(V.out).Individually
switchcameras,orstartandstoppredefinedcamerasequences,
dependingonconfiguration.This
featureisonlyavailableifa
camerasequencehasbeenprogrammed.
1. Press pushbutton V.out to stop a camera sequence. The
camera currently switched on will remain active as long as
thepushbuttonispressed.
2. Releasing the  button restarts the camera sequence with a
delayedswitchtothenextcamerainthesequencer
list.
3. Switch sequencer cameras manually by: Stopping the
sequence as described under 1. Briefly release the
pushbutton and press again to switch to the next camera.
Release the pushbutton and keep it released to activate
sequencermode.
6LEDError-red AnilluminatedredLEDindicatesmalfunctions,suchassystem
errorsorvideosignal
failure.Youcanconfiguretheonboard
CamTel
svr
relayssothattheerrorwillalsoactivatearelay.
7LEDOnline-blue AnilluminatedLEDindicatesanonlineconnection.
8LEDLive-blue FlashingupofLEDLiveduringonlineconnectionindicatesongoing
picturetransmission.Theintervalisdeterminedbytheimagerate,
whichinturnisdefinedbyconnectionspeed
(bitrate)andthe
CamTel
svr
operatingmode.
9LEDArmed(alarm
enabled)-yellow
IndicatesthealarmenablestatusofCamTel
svr
.AnilluminatedLED
Armed(alarmenabled)indicatesalarmsbeingforwardedto
receiverunits,dependingondeviceconfigurations.Thealarm
enablestatushasnoimpactonpicturerecording(pre-alarm).
10 LEDAlarm-red AnilluminatedAlarmLEDduringalarmprocessingindicatesthe
CamTel
svr
alarmstatus.Analarmmayrequireconfirmationby
severalreceivers,dependingondeviceconfiguration.
11 USBport Reserved
Item Labeling/description Function