Product specifications

attempts to move the camera while motion detection is enabled and the preset solved, the dome will hesitate
a second to turn off motion detection before it moves.
Warning: Motion detection should not be enabled on a camera that has physical vibration indicated on
the video.
The Program Auto Home allows configuration of the auto home function. The
dome can be set to automatically go to a programmed preset number location
after a programmed time duration of no activity on the dome has occurred. In
addition, the dome can be set to go to its home position upon power-up.
Note: Auto home on power up must be shut off if preset 95 is used to set auto
baud detect.
The Program Tours menu offers a similar array of options. Once a tour (80-87) is
selected, Clear Tour and Clear All Tours function the same as their preset counterparts. The Program Tour
menu may also be entered directly by calling the tour from the keyboard while the keyboard is in Program Mode.
Each tour is a series of up to 32 events or actions. Each tour action is programmed independently, and steps can
be inserted or deleted by pressing the AUX 1 or AUX 2 keys.
Tour actions include:
• Preset — Calls a selected preset. The preset can be programmed for its
calling speed (1 to 10 with 10 fastest). Therefore, a camera can be moved
from one preset to another to emulate a typical security officer walk.
• AUX On — Allows the Relay to be turned on.
• AUX Off — Allows the Relay to be turned off.
• Call Tour — Calls another tour. Once the called tour is completed, control
is returned to the calling tour.
• Call Autotour — Calls an autotour sequence. Once the called autotour is
completed, control is returned to the calling tour. This step will execute
one time only, even if programmed to repeat.
• Dwell — Inserts a “wait” cycle, from 1 to 99 seconds, between actions.
• Acknowledge Alarm — Acknowledges and resets the current (first-in,
first-out) alarm action.
• Repeat Tour — Goes back to the beginning of the tour and starts over
again, creating a programming “loop.”
• No Action — Skips this step. A tour action may be temporarily set to no
action; when returned to any of the other functions, the other parameters
will be restored without reprogramming them.
• Save Status — Typically used at the beginning of a tour, this step will
save the current camera position and function, including autopan. This
would be used with the next option.
• Recall Status — Returns the camera back to where it was when the Save
Status command was issued. This is typically used at the end of a tour to
restore the camera to where it was before the tour began.
XX134-40-00 Rev 104 SurveyorVFT Camera Dome Programming Programming Menus • 19