User guide
Table Of Contents
- I
- Introduction
- Distance Solution
- Installation
- Step One: Ensure That Attached Devices Function Properly
- Step Two: Set Up Device Router
- Step Three: Clear the Node Mapping Table of the Host Router
- Step Four: Set Up Host Router
- Step Five: Run Connection Check
- Step Six: Run Subsystem Device Check
- Step Seven: Set Operating Mode
- Step Eight: Power Down Sequence (optional)
- Step Nine: Power Up Sequence (optional)
- Operation
- Installation
- SCSI-Fibre Channel Fabric Connectivity A5814A-003
- System Maintenance
- Serial Port Diagnostics
- Brocade 2800 Fabric Switch
- RAID Manager XP
- Appendix A: SCSI-Fibre Channel Router Specifications
- Appendix B: Diagnostic Status Codes
- Index
Hewlett-Packard SCSI-Fibre Channel Router Installation and User Guide
Revision 2.1.0 Page
41
Appendix B: Diagnostic Status Codes
User Serviceable Diagnostic Status Codes
Status
Code
Description Action
006 Too many SCSI errors recorded. Check all connections and/or replace
the SCSI cables with "known-good"
shielded SCSI cables. User must cycle
the power to clear any lockup cases that
the defective cables may have caused.
058 The SCSI-FC Router detected a FC Unique
ID duplication in the same loop.
Contact Hewlett-Packard for
replacement SCSI-FC Router.
060 The SCSI-FC Router has completed clearing
the Node Mapping Table.
068 An illegal host mode has been used. Return to the proper host mode and
recycle power on the SCSI-FC
Router.
Table B-1. Diagnostic Status Codes for Fault LED