User guide
Table Of Contents
- I
- Introduction
- Distance Solution
- Installation
- Step One: Ensure That Attached Devices Function Properly
- Step Two: Set Up Device Router
- Step Three: Clear the Node Mapping Table of the Host Router
- Step Four: Set Up Host Router
- Step Five: Run Connection Check
- Step Six: Run Subsystem Device Check
- Step Seven: Set Operating Mode
- Step Eight: Power Down Sequence (optional)
- Step Nine: Power Up Sequence (optional)
- Operation
- Installation
- SCSI-Fibre Channel Fabric Connectivity A5814A-003
- System Maintenance
- Serial Port Diagnostics
- Brocade 2800 Fabric Switch
- RAID Manager XP
- Appendix A: SCSI-Fibre Channel Router Specifications
- Appendix B: Diagnostic Status Codes
- Index
Hewlett-Packard SCSI-Fibre Channel Router Installation and User Guide
Revision 2.1.0 Page
37
5.2.4.1.6 ‘H’: Download SCSI-FC Router Microcode
This function is used to update the microcode for the local host router.
1. Ensure that the SCSI-FC Router is in the host mode.
2. Enter the upper-case letter ‘H’.
3. Click on the open file icon in the tool menu.
4. Browse the local computer to select the microcode file that will be downloaded to
the local router.
5. Wait for download to complete to begin normal operations.
Warning: Do not download new microcode to the SCSI-FC if the SCSI-FC is
being utilized by the operating system. The SCSI-FC will reset itself after the
download is complete, which can cause lost I/Os and system panic.
5.2.4.1.7 ‘D’: Download SCSI-FC Router Microcode
This function is used to update the microcode for the local device router.
1. Disconnect the Fibre Channel cable from the device router.
2. Power off the device router.
3. Change the device router from Device mode to Host mode.
4. Power on the device router.
5. Activate the PROCOMM Plus software (see Section 5.2.3)
6. Enter the upper-case letter ‘D’ for device router.
7. Click on the open file icon in the tool menu.
8. Browse the local computer to select the microcode file that will be downloaded to
the local router.
9. After download is complete, power off the router.
10. Change the device router from Host mode back to Device mode.
11. Power off the device router.
12. Reconnect the Fibre Channel cable to the device router.
13. Power on the device router.
Warning: Do not download new microcode to the SCSI-FC if the SCSI-FC is being
utilized by the operating system. The SCSI-FC will reset itself after the download is
complete, which can cause lost I/Os and system panic.
5.2.4.1.8 ‘q’: Quit Serial Port Service Utility
When serial port diagnosis is complete, it is recommended that the user actively quit the
program by selecting this menu option. This alerts the computer running PROCOMM that
the serial port connection has been closed and no more data will be forthcoming.