User guide
Table Of Contents
- I
- Introduction
- Distance Solution
- Installation
- Step One: Ensure That Attached Devices Function Properly
- Step Two: Set Up Device Router
- Step Three: Clear the Node Mapping Table of the Host Router
- Step Four: Set Up Host Router
- Step Five: Run Connection Check
- Step Six: Run Subsystem Device Check
- Step Seven: Set Operating Mode
- Step Eight: Power Down Sequence (optional)
- Step Nine: Power Up Sequence (optional)
- Operation
- Installation
- SCSI-Fibre Channel Fabric Connectivity A5814A-003
- System Maintenance
- Serial Port Diagnostics
- Brocade 2800 Fabric Switch
- RAID Manager XP
- Appendix A: SCSI-Fibre Channel Router Specifications
- Appendix B: Diagnostic Status Codes
- Index
Hewlett-Packard SCSI-Fibre Channel Router Installation and User Guide
Revision 2.1.0 Page
32
14. After download is complete, power off the router.
15. Change the device router from Host mode
back to Device mode.
16. Power off the device router.
17. Reconnect the Fibre Channel cable to the device router.
18. Power on the device router.
5.1.4.1.8 ‘q’: Quit Serial Port Service Utility
When serial port diagnosis is complete, it is recommended that the user actively quit the
program by selecting this menu option. This alerts the computer running Windows
HyperTerminal that the serial port connection has been closed and no more data will be
forthcoming.