User guide
Table Of Contents
- I
- Introduction
- Distance Solution
- Installation
- Step One: Ensure That Attached Devices Function Properly
- Step Two: Set Up Device Router
- Step Three: Clear the Node Mapping Table of the Host Router
- Step Four: Set Up Host Router
- Step Five: Run Connection Check
- Step Six: Run Subsystem Device Check
- Step Seven: Set Operating Mode
- Step Eight: Power Down Sequence (optional)
- Step Nine: Power Up Sequence (optional)
- Operation
- Installation
- SCSI-Fibre Channel Fabric Connectivity A5814A-003
- System Maintenance
- Serial Port Diagnostics
- Brocade 2800 Fabric Switch
- RAID Manager XP
- Appendix A: SCSI-Fibre Channel Router Specifications
- Appendix B: Diagnostic Status Codes
- Index
Hewlett-Packard SCSI-Fibre Channel Router Installation and User Guide
Revision 2.1.0 Page
iii
BCIQ EMC Statement & License Number (Taiwan)
(TBD)
Harmonics Conformance (Japan)
(N/A)
German Noise Declaration
Schalldruckpegel Lp = 50 dB(A)
Am Arbeitsplatz (operator position)
Normaler Betrieb (normal operation)
Nach ISO 7779:1988 / EN 27779:1991 (Typprüfung)
Laser Safety
A. Certification and Classification Information
This product contains a laser internal to the Optical Link Module (OLM) for connection to the Fibre communications port.
In the USA, the OLM is certified as a Class 1 laser product conforming to the requirements contained in the
Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter J. The certification is indicated
by a label on the plastic OLM housing.
Outside the USA, the OLM is certified as a Class 1 laser product conforming to the requirements contained in IEC
825-1:1993 and EN 60825-1:1994, including Amendment 11:1996.
The OLM includes the following certifications:
• UL Recognized Component (USA)
• CSA Certified Component (Canada)
• TUV Certified Component (European Union)
• CB Certificate (Worldwide)
B. Product Information
Each fiber channel port optionally contains a transmitter and receiver optical subassembly (optical link module).
The transmitter subassembly contains internally a semiconductor laser diode in the wavelength range of 850 to
1300 nanometers. In the event of a break anywhere in the fibre path, the OLM control system prevents laser
emissions from exceeding Class 1 levels.
Class 1 laser products are not considered hazardous.
WARNING
There are no user maintenance or service operations or adjustments to
be performed on any OLM model.