User guide
Table Of Contents
- I
- Introduction
- Distance Solution
- Installation
- Step One: Ensure That Attached Devices Function Properly
- Step Two: Set Up Device Router
- Step Three: Clear the Node Mapping Table of the Host Router
- Step Four: Set Up Host Router
- Step Five: Run Connection Check
- Step Six: Run Subsystem Device Check
- Step Seven: Set Operating Mode
- Step Eight: Power Down Sequence (optional)
- Step Nine: Power Up Sequence (optional)
- Operation
- Installation
- SCSI-Fibre Channel Fabric Connectivity A5814A-003
- System Maintenance
- Serial Port Diagnostics
- Brocade 2800 Fabric Switch
- RAID Manager XP
- Appendix A: SCSI-Fibre Channel Router Specifications
- Appendix B: Diagnostic Status Codes
- Index
Hewlett-Packard SCSI-Fibre Channel Router Installation and User Guide
Revision 2.1.0 Page
29
6. Chose Xmodem in the Protocol box.
7. Click on Browse to search on the local computer or network, to select the microcode
file that will be downloaded to the local router. Click on the microcode filename, then
click Open. The microcode filename will appear in the Filename box of the Send File
dialog box. Click Send to start the download.
8. At this point, the actual download will commence, provided that the process has not
timed out, as mentioned just prior.
9. Wait for download to complete to begin normal operations.
Warning: Do not download new microcode to the SCSI-FC if the SCSI-FC is
being utilized by the operating system. The SCSI-FC will reset itself after the
download is complete, which can cause lost I/Os and system panic.