User guide
Table Of Contents
- I
- Introduction
- Distance Solution
- Installation
- Step One: Ensure That Attached Devices Function Properly
- Step Two: Set Up Device Router
- Step Three: Clear the Node Mapping Table of the Host Router
- Step Four: Set Up Host Router
- Step Five: Run Connection Check
- Step Six: Run Subsystem Device Check
- Step Seven: Set Operating Mode
- Step Eight: Power Down Sequence (optional)
- Step Nine: Power Up Sequence (optional)
- Operation
- Installation
- SCSI-Fibre Channel Fabric Connectivity A5814A-003
- System Maintenance
- Serial Port Diagnostics
- Brocade 2800 Fabric Switch
- RAID Manager XP
- Appendix A: SCSI-Fibre Channel Router Specifications
- Appendix B: Diagnostic Status Codes
- Index
Hewlett-Packard SCSI-Fibre Channel Router Installation and User Guide
Revision 2.1.0 Page
i
Copyright
This document (and the information herein) is the property of Vicom Systems, Inc. It has been reproduced by
Hewlett-Packard with the expressed permission of Vicom to meet the purpose for which it was delivered.
This document may not otherwise be copied or reproduced in whole or in part, nor used or revealed to any person
in any manner except to meet the purposes for which it was delivered. Additional rights and obligations regarding
this document and its contents may be defined by a separate written agreement with Vicom, and if so, such an
agreement shall be controlling.
Vicom reserves the right to make improvements and/or changes to this manual without incurring an obligation to
incorporate such changes or improvements in units previously sold or shipped. This document has been carefully
reviewed, but Vicom nor Hewlett-Packard cannot be held responsible for unintentional errors or omissions. It is
provided “as is” without express or implied warranty.
Vicom
Systems, Inc.
47281 Bayside Parkway.
Fremont, CA 94538.
Trademark
SCSI-FC Router
is a trademark of Hewlett-Packard Company.
SCSI-Fibre Channel Router
is a trademark of Hewlett-Packard Company
HP-UX
is a registered trademark of Hewlett-Packard Company.
MPE
is a registered trademark of Hewlett-Packard Company.
Windows NT
, Windows 98
and Windows HyperTerminal
are registered trademarks of Microsoft Corporation.
This document (and the information herein) is the property of Vicom. It may not be copied or reproduced in whole or in part, nor
used or revealed to any person in any manner except to meet the purposes for which it was delivered. Additional rights and
obligations regarding this document and its contents may be defined by a separate written agreement with Vicom and if so, such
an agreement shall be controlling.
Vicom reserves the right to make improvements and/or changes to this manual without incurring an obligation to incorporate
such changes or improvements in units previously sold or shipped. This document has been carefully reviewed, but Vicom
cannot be held responsible for unintentional errors or omissions. It is provided “as is” without express or implied warranty.
2001 Vicom Systems. All rights are reserved. This publication may not be stored, transmitted, or copied except as
authorized in writing by the manufacturer.
http://www.vicom.com
Phone: (510) 743-1130
Fax: (510) 743-1131