User guide
Table Of Contents
- I
- Introduction
- Distance Solution
- Installation
- Step One: Ensure That Attached Devices Function Properly
- Step Two: Set Up Device Router
- Step Three: Clear the Node Mapping Table of the Host Router
- Step Four: Set Up Host Router
- Step Five: Run Connection Check
- Step Six: Run Subsystem Device Check
- Step Seven: Set Operating Mode
- Step Eight: Power Down Sequence (optional)
- Step Nine: Power Up Sequence (optional)
- Operation
- Installation
- SCSI-Fibre Channel Fabric Connectivity A5814A-003
- System Maintenance
- Serial Port Diagnostics
- Brocade 2800 Fabric Switch
- RAID Manager XP
- Appendix A: SCSI-Fibre Channel Router Specifications
- Appendix B: Diagnostic Status Codes
- Index
Hewlett-Packard SCSI-Fibre Channel Router Installation and User Guide
Revision 2.1.0 Page
4
5. Attach the device router to the desired SCSI device(s) as shown in Figure 2-1. Ensure
that cable and connectors are securely fastened.
• To locate the SCSI-FC Router SCSI connector, see Figure 2-4.
• For the proper cable specifications, see Section 4.1.1.
Figure 2-1. Completed Setup of the Device Router
2.1.3 Step Three: Clear the Node Mapping Table of the Host Router
For further information on the role of the Node Mapping Table, see Section 2.2.3.5.
1. Ensure that the host router is powered off and that it is not connected to the device router.
2. On SW2 of the host router, set DIP switches 4 and 5 in the down position to clear the
Node Mapping Table.
3. Power on the host router. The power LED (green) should be solid on. If the power LED is
off, see Section 4.3 (Power LED Not Lit)
4. When the Fault LED (yellow) is solid on and the Status LED (green) is blinking, it indicates
that the Node Mapping Table has been cleared. (To locate the front and rear Fault LEDs,
see Figure 2-3 and Figure 2-4, respectively).
Note: When the Node Mapping Table has been cleared, the Status LED (green) blinks a
status code of 060 as described in Table B-1 (Diagnostic Status Codes) in Appendix B. To
decipher the LED read-out, see Section 2.2.1.4.
5. This process will take approximately 10 seconds.
6. Power off the host router.
2.1.4 Step Four: Set Up Host Router
1. Ensure that the host router is powered off.
2. On SW1 of the host router, set all DIP switches to the down position.
(To locate SW1, see Figure 2-4.)
3. Attach the host router to the device router with the appropriate fiber channel cable.
Ensure that cable and connectors are securely fastened.
(To ensure proper cable specifications, see Section 4.1.3.)
4. At this point the host/server should not be attached, as shown in Figure 2-2.
Figure 2-2. Completed Setup of the Host Router
A
ttached SCSI Device
Device Router
Disk Array
SCSI cable
A
ttached SCSI Device
Fibre Channel
SCSI cable
Host Router
Device Router
12H Disk
Array
Optic cable