SDS

Waterless VapoPad
Revision Date: April 9, 2017 Page 4 of 7
Respiratory protection: If engineering controls do not keep airborne concentrations below acceptable limits an approved
respirator must be worn. An organic chemical cartridge respirator should be used if excessive vapor or mists are present. Seek
guidance from your respiratory protection supplier or your health and safety expert.
Thermal hazards: Not applicable based on recommended uses.
General provisions: Minimize exposure to skin and avoid generation of mists or excessive vapor. Ensure appropriate personal
protective equipment is available in the workplace. Respect all appropriate legislation regarding health and safety in the
workplace and follow all recommends from your health and safety committee.
SECTION 9: Physical and chemical properties
Appearance: Clear and colorless, to pale yellow liquid
Odor/odour: Menthol odor
Odor/odour threshold: Not available
pH: Not available
Melting point/freezing point: Not available
Initial Boiling Point and
boiling range: Not available
Flash point: 63°C (145°F)
Evaporation rate: Not available
Flammability (solid, gas): Not applicable
Upper/lower flammability or explosive limits
Flammability limit – lower %): Not available
Flammability limit – upper (%): Not available
Explosive limit – lower (%): Not available
Explosive limit – upper (%): Not available
Vapor/Vapour pressure: Not available
Vapor/Vapour density (air=1): Not available
Relative density (water = 1): Density: 0.92716 g/cm
3
(7.737 lbs/gal)
Solubility(ies): Difficult to mix with water.
Partition coefficient
(n-octanol/water): Not available
Auto-ignition temperature: Not available
Decomposition temperature: Not available
Viscosity: Not available
SECTION 10: Stability and Reactivity
Reactivity: Stable under normal anticipated conditions of use, but may react with
incompatible materials.
Chemical stability: Stable under normal anticipated conditions of use.
Possibility of hazardous reactions: Hazardous reactions are not anticipated.
Conditions to avoid: Keep out of direct sunlight and away from sources of ignition. Avoid contact with
incompatible materials. No other known conditions to avoid.
Incompatible materials: Strong oxidizing agents and bases.
Hazardous decomposition products: Product is not anticipated to decompose.
SECTION 11: Toxicological information
Information on likely routes of exposure: Ingestion, inhalation, contact with skin and eyes.
Symptoms related to the physical, chemical, and toxicological characteristics: May cause eye irritation including tearing and
redness. May cause skin sensitization which may result in redness, irritation and swelling. May cause skin irritation. May cause
respiratory tract irritation and drowsiness dizziness and hallucinations if ingested in very large quantities.