Specifications

100% SETTING BY KEY OPERATION
Percentage measurements per 100% reference value set by key operation.
(1) Press the LLJ key until P SEt appears.
M sign and some value will start blinking.
The value shows 100% reference value currently
set.
(2) Pressing the [73 key will display "0" and bar
graphs under it blinking, to start manual setting
of the reference value for 100%.
Reference setting
p. set
m
n n n v
u.u u A
Manual setting start
n v
m m
(3)
(4)
Pressing the [TJ key further will change the
number of the last digit of the display in the
following sequence.
r—
I
«--Minus mark
-=> —i
I
Decimal point
Pressing the GO key will shift the number at
the last digit of the display to the left. Thus,
select optional number by the [7] key, then shift
it to the left by the [TJ key, and set a reference
value for 100% finally.
Reference value
%
m m
Digit shifting
3D
m
(5) After displaying the reference value, press the
IS I key to memorize the value.
A beep comes out and the mode turns to percentage
measurement mode.
Manual setting finish
35 I %
E)
* The percentage display division will automatically vary as in the case
of SETTING WITH A REFERENCE SAMPLE, in page 10.
- 11 -