Operation Manual

27
Final Setup And Initial Startup - Plumbed
This chapter covers setting the machine up to receive water directly from a pressurized water source. If
you have completed all the steps in Chapter 10 and are NOT going to plumb the machine at this time, skip
this chapter and go to Chapter 12.
WARNING: For those plumbing their machines to an existing water source, it is important to com-
plete Chapter 10 to verify that the reservoir option is working correctly. If you have not already
done so, go back to Chapter 10 and complete that set up and start up procedure before implement-
ing the instructions below.
WARNING: Allow the machine to completely cool off before proceeding. Hot surfaces, hot water,
and steam can cause serious burns!
WARNING: TURN THE POWER SWITCH TO “POSITION 0” and UNPLUG THE MA-
CHINE BEFORE BEGINNING THIS PROCESS! Until told to do so later in this section, DO
NOT plug the machine’s power cord back in!
Plumbed Water Supply
You should have already verified that the machine is properly drawing water from the reservoir and is
heating up the brew boiler and steam boiler. This chapter covers switching the water supply source from the
reservoir (already tested in Chapter 10) to the plumbed option and running the machine from an external water
source. To set up the machine to run from the plumbed source, follow these instructions:
CAUTION: When plumbing the machine in, there should be a valve at the source capable of shut-
ting off the water supplying the DD. That valve can be used in an emergency situation (such as
a leak), or when it becomes necessary to disconnect the machine from the supply. Check with a
licensed plumber for more information.
1 Unplug the machine and allow it to cool to room
temperature
2 Remove the cup warming tray
3 With a towel in hand to catch drips, lift the hose out
of the reservoir.
4 Remove the filter from the end of the hose by simply
pulling it off, and gently shake the hose into the towel to
remove as much water as possible.
5 Lift the reservoir out of the machine, empty its con-
tents into a sink, and dry the reservoir. Place the reser-
voir off to the side.
6 To set the machine to use the plumbed water line, the
gray lever on the bottom of the machine must be turned
so that it points to the LEFT side of the machine (when facing the machine from the front). That is, pointing
to the same side as the steam wand as seen here.
CAUTION: If this lever is in the wrong position, or the source selected has an insufficient water sup-
ply, the pump can be run dry and damaged. Damage from operating the machine with insufficient
water supply is not covered by the warranty.