Instruction Manual

6
TERMINALS AND CONTROLS
13. Remote Gain Input Socket
Use t o plug in the supplied r emote bass level contr oller .
14. Input Mode Select Switch
Use t o select M ASTER or SLAVE input m ode.
15. Slave Input / Output
RCA input and output connections used for amplifier st r apping.
SET UP SECTION
To cor r ectly set the gain control of the am plifier to match that of the sour ce (headunit) use the following setup routine:
Turn t he gain contr ol to minimum on the amplifier.
Ensur e the bass boost is set to 0 dB.
On the headunit set all cr ossovers ( if applicable) to flat and both bass and tr eble to zero.
Turn up the sour ce (headunit) to approx 3 / 4 volume.
Very slowly tur n up the gain on the amplifier unt il distor tion can be hear d in any of t he subwoofer s or unt il the volume r eaches
an uncomfor t able listening level when this is reached tur n down t he gain contr ol slightly.
The gain control is now set.
The sett ing of the cr ossover will depend on what kind of speaker you ar e installing.
For a subwoofer it is r ecommended that the crossover is set t o Low Pass and the fr equency is set to match that of the
speakers specifications, or your preferred frequency - this is usually about 6 0 - 1 2 0 Hz.
Note:
By using the cr ossovers cor rectly you will not only lengthen the life of your speakers but you will also get better performance
fr om them. To opt imise your setup seek the advice of a pr ofessional installation engineer or visit your local VIBE audio dealer.