Instruction Manual

4
TERMINALS AND CONNECTIONS
5 7 9 11 13 15
4
6
8 10 12 14
231
1. Power Input 1
Only 0 gauge cable should be used for the power and ground connection t o the am plifier .
The power cable should connect dir ectly t o the batter ies with a 9 0 0 amp fuse inline no
fur ther t han 1 8 inches in wire length fr om the battery and this fuse must be fitted befor e
the power cable enter s a bulkhead.
Please ensur e that the fuse is not fitted until inst allation is complete and all wiring is checked.
Rubber gr om mets must be used when passing the power cable thr ough a bulkhead to
pr event the cable becoming chaffed or cut.
The ground cable should be connected directly to the chassis ground of the vehicle and ideally
to bare met al.
The ground cable length should be kept to an absolute m inimum.
It is not r ecommended that you connect the ground cable to the vehicles seat belt ancor points.
A minimum of 1 8 gauge cable should be used for t he r emot e tur n on connection.
The cable should be run with the sam e car e and attention as the power cable and use gromm ets
if necessar y.