INSTRUCTION U L MANUA BlackDeath Bass 2 Model: BLACKDEATHBASS2-V1 www.vibeaudio.co.uk To ensure maximum performance and safety, please follow this manual.
OWNERS MANUAL Congr atulations on pur chasing your VIBE amplifier , please r ead this manual in or der to fully under stand how to get the best r esults fr om this pr oduct and ensur e that all advice on how to look after the pr oduct is followed. Thank you for buying VIBE, we hope you enjoy listening to your pr oduct as much as we enjoyed cr eating it. ATTENTION An after mar ket audio amplifier will place an additional load on the vehicles char ging system.
POWER CONNECTIONS Headunit remote turn on Fuse close to battery Chassis ground Battery Battery Battery
TERMINALS AND CONNECTIONS 1 4 3 8 6 5 7 2 10 9 12 11 13 14 15 1. Power Input 1 Only 0 gauge cable should be used for the power and gr ound connection to the amplifier . The power cable should connect dir ectly to the batter ies with a 9 0 0 amp fuse inline no fur ther than 1 8 inches in wir e length fr om the batter y and this fuse mus t be fitted befor e the power cable enter s a bulkhead. Please ensur e that the fuse is not fitted until installation is complete and all wir ing is checked.
TERMINALS AND CONNECTIONS 2. Power Input 1 Only 0 gauge cable should be used for the power and gr ound connection to the amplifier . The power cable should connect dir ectly to the batter ies with a 9 0 0 amp fuse inline no fur ther than 1 8 inches in wir e length fr om the batter y and this fuse mus t be fitted befor e the power cable enter s a bulkhead. Please ensur e that the fuse is not fitted until installation is complete and all wir ing is checked.
TERMINALS AND CONTROLS 13. Remote Gain Input Socket Use to plug in the supplied r emote bass level contr oller . 14. Input Mode Select Switch Use to select M ASTER or SLAVE input mode. 15. Slave Input / Output RCA input and output connections used for amplifier str apping. SET UP SECTION To correctly set the gain control of the amplifier to match that of the source (headunit) use the following setup routine: Turn the gain control to minimum on the amplifier. Ensure the bass boost is set to 0 dB.
AMPLIFIER STRAPPING Two VIBE BlackDeath Bass 2 amplifiers are capable of being strapped together to deliver the combined output of both amplifiers into a single channel. NOTE: only identical amplifiers may be strapped together. Strapping procedure · Connect the RCA input from the source unit to the left and right RCA input of the master amplifier. · Connect a mono RCA lead between the SLAVE OUT output of the master amplifier and the SLAVE IN input.
SINGLE AMPLIFIER CONFIGURATION
STRAPPED AMPLIFIER CONFIGURATION
SPECIFICATIONS Model: BLACKDEATHBASS2-V1 Dimensions: Width: 1000mm (39.4”) Depth: 300mm (11.8”) Height: 75mm (3”) Frequency response: 10Hz - 350Hz Total harmonic distortion (THD): 1% Signal to noise ratio (SNR): >90dB Input sensitivity: 0.2v - 10v Technical Enquir es call 0 9 0 6 7 0 3 1 4 2 0 Calls cost 5 0 p per minute call costs cor r ect at date of publication (0 1 / 0 5 / 1 1 ) Hour s of business 9 .0 0 am - 5 .
LIMITED WARRANTY T All VIBE products carry a full 12 months warranty, valid from the date of the original receipt and proof of purchase. In order to validate this warranty, the warranty card should be returned to VIBE within seven days of the original purchase date. The original receipt and packaging should also be retained for this twelve month period.
