Tus neeg siv phau ntawv

Flush Mount Installation
• After nding a suitable position for the tweeters place the cut out template for the
tweeter in position and mark around it.
• Before cutting the holes double check that no brake, fuel lines or wiring harnesses are
likely to get damaged.
• Ensure that the tweeter when tted will not catch on any moving parts such as door /
window handles.
• If mounting in a door check that the window can still be fully lowered before installing.
• Cut out the hole carefully.
• Place the entire tweeter into the cut out hole.
• From the back push the metal ring over the rear of the casing until it is tight into the
cutout hole.
• After nding a suitable position for the tweeters place the cut out template for the
tweeter in position and mark around it.
• Before cutting the holes double check that no brake, fuel lines or wiring harnesses are
likely to get damaged.
• Ensure that the tweeter when tted will not catch on any moving parts such as door /
window handles.
• If mounting in a door check that the window can still be fully lowered before installing.
• Cut out the hole carefully.
• Position the metal xing ring centrally, behind the cut out hole.
• Pass the tweeter cable through the central hole in the bottom of the case and the metal
xing ring..
7