User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 2 Getting Started
Setting up the instrument
32 T-BERD/MTS 5800 Getting Started Manual
Figure 16 illustrates the LED panel for a SONET application in
ANT mode.
To specify the LED results mode
1 Select the “Test” icon.
The Main screen appears.
2 Select Tools > Customize.
The Customize User Interface Look and Feel screen
appears.
3 Select the Result/Setup Terminology field, and then select
ANT or TestPad mode.
4 Select Close to store the result mode and return to the
Main screen.
Figure 16 SONET LED Panel in ANT mode