Manual

Chapter 7 Connectivity
Establishing connection
54 User Manual 7SMART102 Rev006
2 Make sure the network configuration onto the PC is set to the Dynamic mode:
a Cl
ick on Start > Control Panel.
b Double click on Network Connection.
c Double click on Local Area Connection.
d In the dialog box, click on Properties.
e Check the parameter Internet Protocol (TCP/IP) is selected ( ) and click
once on it (underlined in blue)
f Click on Properties button.
g On the tab General, check the parameter Obtain an IP address automati-
cally is selected ( ); if not, click to select it.
h Click on Ok and close all the dialog boxes opened onto the PC.
Configuring the SmartOTDR via Ethernet
1 In the Home page, validate the Connectivity icon.
2 In the connectivity page, validate the Ethernet icon
3 In the I/O Interfaces box, configure the following parameters:
Remote Screen
Remote screen = Session or Permanent must be confirmed in both cases, in the Inter-
face E/S window.
Figure 41 Internet Protocol