Manual

Table Of Contents
Chapter 6 Microscope application
Using the microscope
40 User Manual 7SMART102 Rev006
Using the microscope
Running an automated test
1 Launch the microscope application.
2 Connect a fiber to the probe inspection tip.
3 Focus the end face image:
Use the focus control wheel if a P5000i microscope or the autofocus trigger if a
FiberChek microscope.
The focus meter will indicate the focus level.
The focus meter will be green if Advanced Focus = Yes and the focus level is
sufficient for automated analysis.
4 Touch the Test softkey or press the test button on the microscope
The Test softkey will be accessible if the Capture Button setting = Freeze &
Test.
The Freeze softkey will be accessible if the Capture Button setting =
Freeze image.
5 View the end face image and note the test result:
Pass: green next to result, image outlined in green, green per zone.
Fail: red next to result, image outlined in red, red next to failing zones.
Figure 28 Exampl
e of the result using the P5000i scope
File Name
Focus Meter
Controls
Fiber End
Face Image