Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Safety Information
- 3 Getting Started
- 4 Operation
- 5 Memory Management
- 6 Data Export and Firmware Update
- 7 Maintenance
- 8 Specifications
- 9 Ordering information
- 10 Product Regulatory Compliance
OLP-35V2/-35SC/-38V2 23
MULTI-LAMBDA MODE
4 OPERATION
Display in Auto- mode
When an Auto- signal is detected (Auto- mode needs to be
activated), the wavelength setting switches automatically to the
applied wavelength and can't be changed manually.
Fig. 3 Display in Auto- mode showing one detected wavelength and
the power level.
Multi-Lambda mode
The OLP-3xV2 can receive Multi- signals and display up to
three wavelengths simultaneously. To enable Multi- it has to be
activated on the optical source, connected with the OLP-3xV2
(e.g. Viavi OLS-34/35/38) and Auto- must be switched on at the
OLP-3xV2.
Fig. 4 Multi- mode
J To switch on Auto-:
See “Enabling Auto-Lambda mode” on page 22.