Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Safety Information
- 3 Getting Started
- 4 Operation
- 5 Memory Management
- 6 Data Export and Firmware Update
- 7 Maintenance
- 8 Specifications
- 9 Ordering information
- 10 Product Regulatory Compliance
18 OLP-35V2/-35SC/-38V2
4 OPERATION
SELECTING A WAVELENGTH
The wavelengths that can be selected by pressing this key are an
extract of those contained in the internal wavelength table.
Fig. 2 Wavelength entries
Editing the wavelength table
The wavelength table supports the definition of up to 6
wavelengths.
To edit the wavelength table:
I Auto- is switched off.
1. Press [] to select a wavelength.
2. Long press [].
The wavelength table is in edit mode and the selected
wavelength position is shown (in a box) on the right.
3. Use [+]/[–] to change the wavelength value.
- Press once to change stepwise.
- Hold down the key to increase the step change rate.
4. Press [
] to save the new wavelength.
Wavelength 1
Wavelength 2
Wavelength 3
Wavelength 4
Wavelength 6
Wavelength 5