Manual

Chapter 3 FiberChekPRO Software
FiberChekPRO controls
P5000i Digital Analysis Probe Getting Started Guide
Page 12 ZP-PKG-0574, R500 August 2021
Table 3 describes the controls.
Test View controls
Figure 4 shows the Test View.
Table 3 Live View controls
Control Description
Microscope Allows you to select the specific microscope you want to
have active for displaying on the screen. If multiple
microscopes are connected, each one will appear in a
drop down list.
Optical Settings Allows you to select the best optical settings for the type
of inspection tip that is attached to the probe. You can
select from several preconfigured optical settings or
create your own.
Profile Allows you to select from various PROFILES that contain
the analysis parameters by which PASS/FAIL criteria are
determined. You can select from several preconfigured
profiles or create your own.
Image Controls Provides specific controls for fine tuning the image. In
LIVE view, you can select between viewing at LOW or
HIGH magnification.
Focus Quality Meter A visual gauge that aids in finding the optimal focus point.
Optical focus level is reached when the bar is closest to
the red line.
Test Initiates the automated PASS/FAIL test process.
Save Allows you to capture and save the image as it appears
on the screen.
p5000i-GettingStarted.book Page 12 Tuesday, August 3, 2021 1:15 PM